Map the surfaces losing material
Wear protection starts by locating impact, sliding abrasion and areas where material repeatedly builds up. Chutes, hopper outlets and transfer interfaces can wear at different rates within the same plant. Mark those areas on a drawing or photographs so the specification follows the actual duty.
Match the material to the mechanism
Lining compounds and wear components differ in flexibility, abrasion response and compatibility with temperature or contaminants. Identify oils, chemicals and cleaning conditions as well as the handled product. A recognised product range is a source of options, not a guarantee that every compound suits every surface.
Design the edges, joints and attachment
Poorly located joints or exposed edges can become wear or snagging points. Confirm the substrate condition, bonding or fixing method and the access available for preparation. The lining must preserve required transfer clearances and avoid creating a restriction at discharge.
Use inspection to guide replacement
Record the locations and condition of repaired or relined surfaces. Repeated failure at one point may call for a transfer assessment rather than another like-for-like patch. The resulting scope may combine rubber lining, sheet-rubber selection, belt repair and design review.
Connected services and selection guides
Define the work you need
- Equipment drawings and photos identifying the wear zones
- Material, impact conditions, temperature and contaminants
- Existing lining, substrate condition and attachment method
- Access, lining area and planned return-to-service date
